Hi
Looking for some advice. I've just over 2.0 Mbps upload bandwidth.
The advice for webcasting is to use low setting so 300Kbps
Now 300Kpbs is far less than my upload of speed of 2Mbps
Yet when I do a broadcast my recieven bit rate is awalys well below the target. See attached.
Can anyone explain why. Where are these stats coming from as surely I can get faster than this given my overall upload speed.
Thanks
Simon
Receive bit rates for broadcast
-
- Member
- Posts: 136
- Joined: Tue Sep 20, 2011 12:44 pm
- Location: Lancaster England
Receive bit rates for broadcast
- Attachments
-
- 1543076857403_20181124_141125.jpg
- (3.54 MiB) Not downloaded yet
- Biggles
- Senior Member
- Posts: 1608
- Joined: Tue May 27, 2008 5:14 am
- Location: Watford, England
Re: Receive bit rates for broadcast
Assuming you’re using the Teradek Vidiu device, what version of firmware are you using with this device? The firmware can affect the statistics displayed.
Despite the statistics is displayed, are the results seen at a receiving site acceptable?
Despite the statistics is displayed, are the results seen at a receiving site acceptable?
-
- Member
- Posts: 136
- Joined: Tue Sep 20, 2011 12:44 pm
- Location: Lancaster England
Re: Receive bit rates for broadcast
Hi
Yes using the Teradek running the latest firmware that i download yesterday version 3.0.7
From the test i broadcast and receive at the same location the quality is ok. What worries me is i have occasionally had low bandwidth messages show on the receiving stream. But given the bandwidth showing on a speed test i should be able to cope with this.
Does setting the broadcast site to low bandwidth mode do anything in the event settings? I have set this for all receive sites but can;t change it for the broadcast site.
Thanks
Simon
Yes using the Teradek running the latest firmware that i download yesterday version 3.0.7
From the test i broadcast and receive at the same location the quality is ok. What worries me is i have occasionally had low bandwidth messages show on the receiving stream. But given the bandwidth showing on a speed test i should be able to cope with this.
Does setting the broadcast site to low bandwidth mode do anything in the event settings? I have set this for all receive sites but can;t change it for the broadcast site.
Thanks
Simon
-
- Member
- Posts: 136
- Joined: Tue Sep 20, 2011 12:44 pm
- Location: Lancaster England
Re: Receive bit rates for broadcast
Also when it drops out it jumps back 2-3 minutes is this normal