PSA - apparently all units should have ComTek receivers

Discussions around meetinghouse sound systems, microphones, assisted listening devices, and translation equipment
aclawson
Senior Member
Posts: 760
Joined: Fri Jan 19, 2007 6:28 pm

PSA - apparently all units should have ComTek receivers

#1

Post by aclawson »

I was just told that every meetinghouse should have a ComTek system for the hearing impaired which means that you should have some wireless headsets somewhere in the building. It came up for the first time ever recently and we discovered that we had no such devices.
drepouille
Senior Member
Posts: 2859
Joined: Sun Jul 01, 2007 6:06 pm
Location: Plattsmouth, NE

Re: PSA - apparently all units should have ComTek receivers

#2

Post by drepouille »

Oh, we have them, but they usually hide in some forgotten drawer in the meetinghouse library, and have dead 9-volt batteries. Some members have actually purchased their own receivers, which I believe they can obtain at a discounted rate through the Church somehow.
Dana Repouille, Plattsmouth, Nebraska
bhpeterson
New Member
Posts: 1
Joined: Wed Jul 27, 2016 2:46 pm

Re: PSA - apparently all units should have ComTek receivers

#3

Post by bhpeterson »

Contact Comtek at 800 496 3463 and ask for an Assisted Listening Device for LDS chapels. They have member direct pricing for the LDS Church.
RyanGard1977
Member
Posts: 116
Joined: Sun Jul 19, 2015 10:26 pm
Location: Denver, Colorado

Re: PSA - apparently all units should have ComTek receivers

#4

Post by RyanGard1977 »

Your local FM/Facilities Group should be the ones responsible for having the COMTEK systems installed into the buildings and providing the 2 or 3 COMTEK listening devices issued to each building. These are only tied into the Chapel sound system. The COMTEK Broadcast device is generally located wherever the electronics/amplifier boxes are at for the Chapel Sound System. Depending upon how old your building is.

The links below are what they may look like.
The newer units:
http://www.harriscomm.com/media/catalog ... rcvr_2.jpg

Older units
http://www.weazelfactory.com/Site/Comte ... r72b_1.png

This is what the COMTEK Broadcast device looks like in most cases, usually found in the sound/AV cabinet where the chapel Amp is located. (they are generally in metal cabinets that swing open (key controlled) and will find AMPS that control the primary room, cultural hall, and YW room as well)
http://comtek.com/wp-content/uploads/2013/04/BST-75.jpg


Let me know if you have any questions.

Ryan
Ryan Gardner
StevePoulsen
Church Employee
Church Employee
Posts: 112
Joined: Tue Oct 19, 2010 11:10 am
Location: Utah, USA
Contact:

Re: PSA - apparently all units should have ComTek receivers

#5

Post by StevePoulsen »

RyanGard1977 wrote:Your local FM/Facilities Group should be the ones responsible for having the COMTEK systems installed into the buildings and providing the 2 or 3 COMTEK listening devices issued to each building. These are only tied into the Chapel sound system. The COMTEK Broadcast device is generally located wherever the electronics/amplifier boxes are at for the Chapel Sound System. Depending upon how old your building is.

The links below are what they may look like.
The newer units:
http://www.harriscomm.com/media/catalog ... rcvr_2.jpg

Older units
http://www.weazelfactory.com/Site/Comte ... r72b_1.png

This is what the COMTEK Broadcast device looks like in most cases, usually found in the sound/AV cabinet where the chapel Amp is located. (they are generally in metal cabinets that swing open (key controlled) and will find AMPS that control the primary room, cultural hall, and YW room as well)
http://comtek.com/wp-content/uploads/2013/04/BST-75.jpg


Let me know if you have any questions.

Ryan
Note, That about a year ago, when change to Listen as the standard manufacturer. New buildings, and older systems where the Comtek system has failed are replaced with Listen branded transmitters and receivers. The two are considered compatible, however older systems may have experienced large amounts of frequency drift which will make them appear non-compatible.

Listen System https://www.listentech.com/shop/product ... -receiver/
Steve Poulsen - Meetinghouse Facilities Technology Engineer
Captain.Moroni
New Member
Posts: 16
Joined: Tue Nov 12, 2013 1:15 am

Re: PSA - apparently all units should have ComTek receivers

#6

Post by Captain.Moroni »

You mentioned 2 brands COMTEK & ListenTech. Did the Church switch from COMTEK to Listen Tech for new installations or replacements?

Just confused as to which is the newer and preferred system.

Also what have other Stakes been using for a multilingual English/Spanish setup? Could we use 2 transmitters, on separate broadcast channels?

Thanks,
russellhltn
Community Administrator
Posts: 34417
Joined: Sat Jan 20, 2007 2:53 pm
Location: U.S.

Re: PSA - apparently all units should have ComTek receivers

#7

Post by russellhltn »

Captain.Moroni wrote:Did the Church switch from COMTEK to Listen Tech for new installations or replacements?
According to the prior post, yes.

Captain.Moroni wrote:Also what have other Stakes been using for a multilingual English/Spanish setup? Could we use 2 transmitters, on separate broadcast channels?
If you're using the two languages at the same time, typically, you'd have a Williams Sound system for carrying the translated audio. If the hearing loss is not too bad, they can use the Williams Sound receivers like those with normal hearing.
Have you searched the Help Center? Try doing a Google search and adding "site:churchofjesuschrist.org/help" to the search criteria.

So we can better help you, please edit your Profile to include your general location.
bayless
New Member
Posts: 11
Joined: Mon Oct 15, 2012 7:56 am

Re: PSA - apparently all units should have ComTek receivers

#8

Post by bayless »

ListenTech is currently offering a Wifi system which allows the hearing impaired to use their smart phone and bluetooth capable hearing aids to listen in the chapel. This eliminates the ComTec device and disposable batteries and gives better hearing quality for each individual because their hearing aids are programmed for their personal needs. Is it possible to upgrade our building to this system if we already have Wifi throughout the building?
russellhltn
Community Administrator
Posts: 34417
Joined: Sat Jan 20, 2007 2:53 pm
Location: U.S.

Re: PSA - apparently all units should have ComTek receivers

#9

Post by russellhltn »

From the ListenTech FAQ:
Q Can you connect the PL-900 ListenWiFi Server to an existing wireless network to stream audio?
A It is not supported at this time as there are multiple implications to the performance of existing WiFi networks. ListenWiFi is focused on good quality low latency audio, and feel we best achieve this as a stand-alone system, which has been fully tested and guaranteed to work.
Have you searched the Help Center? Try doing a Google search and adding "site:churchofjesuschrist.org/help" to the search criteria.

So we can better help you, please edit your Profile to include your general location.
StevePoulsen
Church Employee
Church Employee
Posts: 112
Joined: Tue Oct 19, 2010 11:10 am
Location: Utah, USA
Contact:

Re: PSA - apparently all units should have ComTek receivers

#10

Post by StevePoulsen »

bayless wrote:ListenTech is currently offering a Wifi system which allows the hearing impaired to use their smart phone and bluetooth capable hearing aids to listen in the chapel. This eliminates the ComTec device and disposable batteries and gives better hearing quality for each individual because their hearing aids are programmed for their personal needs. Is it possible to upgrade our building to this system if we already have Wifi throughout the building?

As @russellhltn points out, there are numerous issues with the implementation of these in meetinghouses, consequently, we have not adopted them at this time. The Listen system uses rechargeable batteries, so there is less battery waste.

Captain.Moroni wrote:You mentioned 2 brands COMTEK & ListenTech. Did the Church switch from COMTEK to Listen Tech for new installations or replacements?
It depends,
All new projects in North America use the Listen systems. If an entire system fails, it is also replaced with a Listen. If the existing Comtek continues to function, but more receivers are needed, new comtek, or listen receivers can be added, as they are [generally] compatible.

Captain.Moroni wrote: Also what have other Stakes been using for a multilingual English/Spanish setup? Could we use 2 transmitters, on separate broadcast channels?
You cold, though the Standards only provide for a single transmitter. However Language Wards, and Branches (in North America) are authorized for Williams sound translation systems. These use the same channels as the the ALS systems so you could connect one language to the Williams, and the other to the Comtek/Listen. Most newer receivers are frequency agile so will work with both systems. On nice perk of the listen receivers is they will give a name to the channel. ie Chapel, or Spanish to help users know which channel they have selected. This can help eliminate confusion.
Last edited by StevePoulsen on Mon Nov 13, 2017 2:27 pm, edited 1 time in total.
Steve Poulsen - Meetinghouse Facilities Technology Engineer
Post Reply

Return to “Meetinghouse Audio”