I received six new OptiPlex 9030 computers, four for one FHC, and two for another. Unfortunately, I entered the wrong FHC unit number and LDSmail address in one of the computers. After I realized my mistake, I ran the FHC identification program again, and entered the correct information.
Did that fix my mistake? Should I have just reimaged the computer using F11 to boot to the Recovery partition?
I really do not want that computer to report the wrong FHC unit number through Tivoli data collection.
Wrong FHC unit number entered
-
- Senior Member
- Posts: 2859
- Joined: Sun Jul 01, 2007 6:06 pm
- Location: Plattsmouth, NE
Wrong FHC unit number entered
Dana Repouille, Plattsmouth, Nebraska
- Biggles
- Senior Member
- Posts: 1608
- Joined: Tue May 27, 2008 5:14 am
- Location: Watford, England
Re: Wrong FHC unit number entered
I don't know for sure, but it would seem logical(!) that you can update the FHC unit number via the FHC identification program.
-
- Senior Member
- Posts: 2859
- Joined: Sun Jul 01, 2007 6:06 pm
- Location: Plattsmouth, NE
Re: Wrong FHC unit number entered
I believe I was able to confirm the FHC unit number was changed to the correct value when I ran the new.portalconfig utility, which reported all the detailed information about the FHC.
Dana Repouille, Plattsmouth, Nebraska