Getting a 1041 to change channels
-
- Community Administrator
- Posts: 34492
- Joined: Sat Jan 20, 2007 2:53 pm
- Location: U.S.
Getting a 1041 to change channels
I see this has been discussed in the past, but I see no resolution. Is there a way to get a 1041 to change the channel it's on? The front line GSD tells me it picks it automatically, but it's sticking to CH1 despite another AP using that channel - even after using the mode switch to do a factory reset while leaving the other one on.
Have you searched the Help Center? Try doing a Google search and adding "site:churchofjesuschrist.org/help" to the search criteria.
So we can better help you, please edit your Profile to include your general location.
So we can better help you, please edit your Profile to include your general location.
-
- Senior Member
- Posts: 760
- Joined: Fri Jan 19, 2007 6:28 pm
Re: Getting a 1041 to change channels
Local people have no control over it.
- Biggles
- Senior Member
- Posts: 1608
- Joined: Tue May 27, 2008 5:14 am
- Location: Watford, England
Re: Getting a 1041 to change channels
According to GSC if there is conflict, in range, the WAP will change channel automatically.russellhltn wrote:I see this has been discussed in the past, but I see no resolution. Is there a way to get a 1041 to change the channel it's on? The front line GSD tells me it picks it automatically, but it's sticking to CH1 despite another AP using that channel - even after using the mode switch to do a factory reset while leaving the other one on.