2Wire 3800HGV-B won't play nicely with PIX
Posted: Sun Jan 17, 2010 1:34 pm
The AT&T U-verse connection is up an running at one of the buildings but I am having trouble getting the church managed firewall set up. The device that ships with the service is a 2Wire 3800HGV-B modem/router with all of the expected whistles and bells expected in such a device (firewall, DHCP service, etc). The problem is that SLC can't hit the PIX that is installed on the user side of the device. I have found older instructions that indicate I should set the 2Wire gateway to bridge mode but the step by steps include using options that do not exist - I suspect that they were valid at one point but a firmware update removed them.
Has anybody been able to configure the PIX with this particular gateway? Were you able to find a specific bridge mode or did you DMZ the PIX? Does the PIX serve up DHCP addresses or should that IP be static and outside of a DHCP scope set for the internal router?
Has anybody been able to configure the PIX with this particular gateway? Were you able to find a specific bridge mode or did you DMZ the PIX? Does the PIX serve up DHCP addresses or should that IP be static and outside of a DHCP scope set for the internal router?