Access Point Installation and Configuration

Discussions about Internet service providers (ISPs), the Meetinghouse Firewall, wired and wireless networking, usage, management, and support of Meetinghouse Internet
User avatar
New Member
Posts: 22
Joined: Sat Jan 12, 2008 8:06 pm
Location: Fort Valley, GA

Access Point Installation and Configuration

Postby egowen » Sun Jan 27, 2013 4:12 am

Our FM group recently upgraded our wireless adding a third access point and some wired connections. I notice the access points are all on channel 1 rather than being spread on the three non-overlapping channels (1, 6 and 11). What needs to be done to get this corrected or are the new Cisco AP designed to handle this issue on their own? I also noted that the AP are mounted high in the attic and one is even mounted at the roof angle which would seen to make the radiation pattern less than ideal. Any suggestions?

User avatar
Community Administrator
Posts: 15057
Joined: Tue Nov 27, 2007 8:48 pm
Location: Sandy, Utah

Re: Access Point Installation and Configuration

Postby aebrown » Sun Jan 27, 2013 6:06 am

The wireless channel issue is one that should be handled by your stake technology specialist working with the Global Service Center.

The mounting issue would probably also be spearheaded by the STS, but in this case he would collaborate with the stake physical facilities representative to discuss the issue with the FM group.

Return to “Meetinghouse Internet”

Who is online

Users browsing this forum: No registered users and 2 guests