AVDH1 patch panel - what's the point?

Conversations around originating a webcast for conference, including cameras and mixers.
aclawson
Senior Member
Posts: 712
Joined: Fri Jan 19, 2007 6:28 pm
Location: Commerce Twp, MI

AVDH1 patch panel - what's the point?

Postby aclawson » Sun Sep 13, 2015 10:11 am

Looking at the documentation here http://www.emtechelectronics.com/medias/documents/Visio-Installer_Quick_Guide-_AVDH-1_v1.1d.pdf

AVDH‐1 Camera Patch Panel is to be installed with a BNC‐Male to BNC‐Male Patch Cable between INSTALLED CAMERA and AVDH‐1 CAMERA‐IN on front of panel. If there is no Installed Camera, connect the patch cable between AUX CAMERA and AVDH‐1 CAMERA‐IN


The cable with the video from the camera comes in from behind the equipment rack and is currently plugged directly into the back of the AVDH1 - what would the benefit of adding an extra piece of cable by re-routing this cable to the front of the panel, only to run that extra piece of cable back to the rear of the AVDH1?

russellhltn
Community Administrator
Posts: 20775
Joined: Sat Jan 20, 2007 2:53 pm
Location: U.S.

Re: AVDH1 patch panel - what's the point?

Postby russellhltn » Sun Sep 13, 2015 11:16 am

aclawson wrote:what would the benefit of adding an extra piece of cable by re-routing this cable to the front of the panel, only to run that extra piece of cable back to the rear of the AVDH1?

You can make changes without having to mess with the cabling behind. Perhaps you might add more cameras and a mixer at a later date. It gives local users flexibility without deviating from the church standard.
Have you searched the Wiki?
Try using a Google search by adding "site:tech.lds.org/wiki" to the search criteria.


Return to “Webcasting”

Who is online

Users browsing this forum: No registered users and 1 guest