Re: Balanced output provided for webcast connections
Posted: Tue Apr 23, 2013 12:23 pm
Just wanted to update you all with what I ended up using. The audio from the building had been run straight into the camera RF modulator according to the blueprints and someone cut the line and put in a RDL ST-DA3 distribution amp. There was a bit of humm as well the level issue. A local professional supplier recommended the RDL TX-1A which only runs $35. I connected it in between the MWC and the ST-DA3 and it cleaned up the hum and brought the audio down to the correct level. The ground leads (not -) were not connected on the ST-DA3 so I connected them, that might have helped the hum. The unit doesn't require any power and has gain control for fine tuning. It is a good solution to this issue.