Help installing MLS test version

Discussions around using and interfacing with the Church MLS program.
RossEvans
Senior Member
Posts: 1346
Joined: Wed Jun 11, 2008 8:52 pm
Location: Austin TX
Contact:

Help installing MLS test version

Postby RossEvans » Sat Nov 14, 2009 10:33 am

I need a little handholding to initialize the test version of MLS, which I have downloaded and installed on an XP laptop.

I am immediately prompted to enter my ward's unit number, just as I would for a live installation. But I am intending to use the test install (in this case MLS v 3.1.0b8 beta) populated with the standard test data. I had understood that the test unit has its own fictional unit number.

Do I have the right install package for my purposes? Or do I need to take special steps to use this one with the test data?

jdlessley
Community Moderators
Posts: 6526
Joined: Sun Mar 16, 2008 11:30 pm
Location: USA, TX

Postby jdlessley » Sat Nov 14, 2009 10:48 am

At the point where it asks for the unit number enter 108, the test ward number, and it will install the test data for that unit. For the test stake enter the number 2224445. No special steps are required. The test data can also be installed along with real unit data on a unit administrative computer. The instructions are at the wiki article MLS test data.
JD Lessley
Have you tried finding your answer on the LDS.org Help Center page or the LDSTech wiki?


Return to “MLS Support, Help, and Feedback”

Who is online

Users browsing this forum: No registered users and 1 guest