Page 1 of 1

Audio

Posted: Wed Jun 25, 2014 3:46 am
by dwilton1
I understand the audio from the chapel, overflows as the partition walls are opened, and the reverse for the Cultural hall 3 up to cultural hall 1.

Does the mic inputs work for the each partition as an individual room? Does the Cultural hall 3 control need to be on? Or does this not work like that.

▼ Chapel
----------------------
▼ ▲ Cultural Hall 1 (2-mic inputs)
------------------------
▼ ▲ Cultural Hall 2 (2-mic inputs) as individual room
-------------------------
▼ ▲ Cultural Hall 3 (2-mic inputs) + control (rca + mic input 3)

Re: Audio

Posted: Wed Jun 25, 2014 10:39 am
by Mikerowaved
dwilton1 wrote:Does the mic inputs work for the each partition as an individual room?

That's been my experience.

dwilton1 wrote:Does the Cultural hall 3 control need to be on?

Yes, but only for Cultural hall 3 to operate. #2 is just plug-and-play.

Re: Audio

Posted: Fri Jun 27, 2014 2:08 am
by dwilton1
Thank you for responding. for Cul. Hall#2 I can assume that the mic level for the room is preset at the mixer, since their is no control. Would it hurt the system to connect a in-line xlr volume control, such as, the product below?

http://www.sescom.com/product.asp?item=SES-MKP-29

Re: Audio

Posted: Fri Jun 27, 2014 2:53 am
by russellhltn
dwilton1 wrote:Would it hurt the system to connect a in-line xlr volume control, such as, the product below?

Not likely. I can't tell if the product works with microphones or only for line-level.