Sacrament Tray Filler

Some discussions just don't fit into a well defined box. Use this forum to discuss general topics and issues revolving around the Church and the technology offerings we use and share.
ironhorse2004
New Member
Posts: 12
Joined: Mon Jan 10, 2011 8:41 am

Sacrament Tray Filler

Postby ironhorse2004 » Wed Oct 26, 2011 12:29 pm

I visited a ward the other day and noticed they had a device to fill all of the sacrament cups full of water at the same time. I have looked on the lds catalog and had no luck at finding this device. Where can I find this water tray filler????

User avatar
mfmohlma
Senior Member
Posts: 784
Joined: Thu Feb 28, 2008 5:45 pm
Location: Hillsboro, OR

Postby mfmohlma » Wed Oct 26, 2011 2:36 pm

I'd bet it was "homemade". I've never seen such a device the the buildings I have attended (both new and quite old).

JamesAnderson
Senior Member
Posts: 748
Joined: Tue Jan 23, 2007 2:03 pm

Postby JamesAnderson » Wed Oct 26, 2011 2:37 pm

The trays used for water are not unique to the Church, there are variations made for other churches as well, some are very similar if not the same. That means that in other places it is possible that someone has come up with a device for use in those other situations and someone happened to stumble across it somewhere.

We've also gone through some variations, but usually each tray can hold about 30-40 cups, some have been plastic and those were a little smaller, the last I saw of the round water trays was in the late 80s, and some of those and the rectangular ones had places to drop the cups into (either side of the handle).

Paper cups were common until about ten years ago. Now the small plastic ones are used, and in my ward we found a way to mitigate the sound when one is dropped back into the tray holder, you take a paper towel from the dispenser in the room you prepare the sacrament in although not all rooms will have one, tear it in half down the middle, and lay the halves in the bottom of the tray. Also makes it easy for cleanup as well after the meeting.

User avatar
chrissv
New Member
Posts: 28
Joined: Fri Mar 02, 2007 9:17 am
Location: Dudley, MA
Contact:

Postby chrissv » Wed Oct 26, 2011 6:54 pm

30 years ago when I was a Priest, we had such a device. It hooked to the water faucet, and had a valve/lever which would open up streams over all of the cups at once. Haven't seen anything lately, though.

Frankly, it turned out to be more of a hassle than it saved. The connection to the faucet would often come loose (and spray water everywhere!); if you didn't have the tray sitting just right, it would leak into the bottom of the tray. Plus it didn't really save time.

After a couple of weeks it got relegated to a permanent place under the sink, and we went back to filling the trays manually. By lifting out the top part (which holds the cups), I used to be able to move the tray under the water stream, filling the cups to just the right amount, and then shaking the tray to get rid of the water in between the cups...

-- Steven

ironhorse2004
New Member
Posts: 12
Joined: Mon Jan 10, 2011 8:41 am

Postby ironhorse2004 » Fri Oct 28, 2011 2:17 pm

I guess we will continue the way we are doing it, thanks for your help!!

knuteream
New Member
Posts: 1
Joined: Tue Nov 22, 2011 5:40 pm

Postby knuteream » Tue Nov 22, 2011 5:44 pm

Our ward has one- I'll look at it next time I'm over there and see if it has a label. It's a rectangular dish on a pivot, so that you fill it with water, and then tip it on the pivot to drain water out holes that are spaced to match the cups in the tray. Works slick! It's possible that this one is 30+ yrs old, because it was there (or one virtually identical) when I was a deacon that long ago.

kylehart
New Member
Posts: 49
Joined: Mon May 18, 2009 6:44 pm
Location: Alexandria, VA

Postby kylehart » Sun Nov 27, 2011 7:23 pm

I'd like a device that would automatically insert the cups into the tray.

BA23
New Member
Posts: 1
Joined: Sun Dec 11, 2011 5:41 pm

Postby BA23 » Sun Dec 11, 2011 5:45 pm

knuteream wrote:Our ward has one- I'll look at it next time I'm over there and see if it has a label. It's a rectangular dish on a pivot, so that you fill it with water, and then tip it on the pivot to drain water out holes that are spaced to match the cups in the tray. Works slick! It's possible that this one is 30+ yrs old, because it was there (or one virtually identical) when I was a deacon that long ago.


We had a similar one when I was growing up in California. I would love to buy one for our ward. Did you find out a brand name or is there a sticker or stock number of any kind?

SNRote
New Member
Posts: 5
Joined: Tue Jan 03, 2012 6:46 pm

Postby SNRote » Tue Jan 03, 2012 6:54 pm

I have been preparing sacrament trays for years. I have never seen anything like this. If anyone tracks it down or figures out how to make one let's schedule a group conference call to discuss the "how to's".

willbacon
New Member
Posts: 2
Joined: Thu Apr 12, 2012 11:53 am

Me Too

Postby willbacon » Fri Apr 13, 2012 6:50 am

Our ward had one back in the 80's when I was a YM. Worked great and filled the tray in seconds.

Anyone have luck locating the manufacturer tag or sticker. Would love to get one for our AP boys.


Return to “General Discussions”

Who is online

Users browsing this forum: No registered users and 1 guest