Tech Forum

When I insert an address in the meetinghouse locator search line, all I get now is a list of more street addresses in the area.... I need the names of wards in the area like I used to get.... Am I missing a step?

I just did a search and the locator worked fine.

The only thing I can think is to make sure the address is a valid address.

I believe I found my problem.... The previous version listed the ward or wards closest to the address... the new version simply lists addresses, but when you look to the right at the map, you see these addresses marked on the map and then when you click, you finally see the name of the ward. I just didn't look to the right......

zaneclark wrote:I believe I found my problem.... The previous version listed the ward or wards closest to the address... the new version simply lists addresses, but when you look to the right at the map, you see these addresses marked on the map and then when you click, you finally see the name of the ward. I just didn't look to the right......

The new version also lists the wards on the left side. Look for the heading "Assigned Residential Ward"; you can also click the "Nearby" subtab (it defaults to the "Assigned" subtab).