Tech Forum

I found an odd bug that had me rather confused until I figured out what was going on. Here are the details:

1. On a particular date, we have two events: Event A is at our stake center, and Event B is at another location (not a Church building).
2. Event A was scheduled from 9:00am to 1:00pm
3. Event B was scheduled from 8:00am to 4:00pm.
4. I realized I hadn't included setup and cleanup times for Event A, so I went and entered 60 minutes setup before, and 30 minutes setup after.
5. I saved the event.
6. On the potential conflicts popup, I was shown Event B, but the times were listed as 7:00am to 4:30pm. Note that it should have been 8:00am to 4:00pm, but the setup and cleanup times from Event A were added to Event B. Oops!

Of course, Event B has no setup or cleanup times, since it is not at any location. And I adjusted the setup and cleanup times for Event A as an experiment, and on each save of Event A, the times displayed for Event B included the setup/cleanup times for Event A.

Can you try this again now that 2.0.2 is deployed (it was deployed at 3:30pm today)? I'm trying to reproduce it and it is working correctly.

jdcr256 wrote:Can you try this again now that 2.0.2 is deployed (it was deployed at 3:30pm today)? I'm trying to reproduce it and it is working correctly.

Wow, that was quick. I found the bug on 2.0.1-build 2449, and less than an hour later, it is indeed fixed on 2.0.2-build 2509.

Ah, if only all my problems would go away so quickly!